Amanda Amanda@SOHO Version 3.xx Technical Information PDF herunterladen (Seite 12)

6 Installing and Administering Amanda@SOHO

Connecting Ports

You create an Amanda port by connecting a telephone line (a standard 2-wire line cord)

from your telephone switching system to a standard RJ-11 modular jack on the back of

Amanda. The jack represents one analog (single-line) extension. Amanda can support up

to four ports.

Arrange the ports in a hunt group. Calls should go to port 1 with the highest priority, then

to ports 2, 3, and 4 in that order. Port 4 is the lowest priority. However, port 4 must be

connected to the telephone switching system in order to perform notification. When

Amanda notifies a user that a message has been left (for example, by paging that user or

lighting the message light on the telephone), she uses port 4. Amanda can notify users

only if port 4 is connected to the telephone switching system. Port 4 must also have

outside line access (in the same way that other extensions have outside line access) to dial

out to pagers, etc.

Amanda@SOHO comes in both a US (domestic) and an international casing. The

following diagram shows the domestic hardware:

LINE 1

LINE 2

LINE 3

LINE 4

Power In

OFF

Reset

Hard Disk

Diagnostic

Power On

COM 1 Parallel Port

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 59 60

Keine Kommentare

Amanda Amanda@SOHO Version 3.xx Technical Information Seite 12